How it works
Magnets that click
Every fob and every pocket holds a 10 × 3 mm disc magnet, sealed inside: we pause the print partway, drop the magnets in, and print over them. Bring a fob close and it pulls itself into place.
A ridge that holds on
A 1.5 mm ridge along the bottom of each pocket catches the fob's feet, so a bump or a heavy key ring won't pull it off the wall. To take your keys, lift the fob up about 1.9 mm and out.
Mounting
Two keyhole slots on the back fit standard screws; screws and anchors are in the box. Prefer no holes? The back is flat, and Command strips are included too.
Material
Crafted in matte PLA, 9.8 mm thick. Color details are crafted flush into the board, not painted or glued, so they won't chip or peel.
Care
Wipe with a dry or slightly damp cloth. Keep it out of hot direct sun and away from heaters: PLA softens above about 55 °C.
Sizes
Width depends on how many keys you need. Fob tabs hang a little below the board.
| Style | 2 keys | 3 keys | 4 keys | 5 keys | 6 keys |
|---|---|---|---|---|---|
| Classic | 77 × 79 mm 3.0 × 3.1 in | 112 × 89 mm 4.4 × 3.5 in | 147 × 94 mm 5.8 × 3.7 in | 182 × 94 mm 7.2 × 3.7 in | 217 × 94 mm 8.5 × 3.7 in |
| Brick colonial | 91 × 111 mm 3.6 × 4.4 in | — | 161 × 111 mm 6.3 × 4.4 in | — | 231 × 111 mm 9.1 × 4.4 in |
| Stone French country | — | 116 × 99 mm 4.6 × 3.9 in | 151 × 99 mm 5.9 × 3.9 in | 186 × 99 mm 7.3 × 3.9 in | 221 × 99 mm 8.7 × 3.9 in |
| Your house | 200 × 140 mm 7.9 × 5.5 in | 200 × 140 mm 7.9 × 5.5 in | 200 × 140 mm 7.9 × 5.5 in | 200 × 140 mm 7.9 × 5.5 in | 217 × 140 mm 8.5 × 5.5 in |
Colors
Real Bambu PLA Matte filaments. Use up to 5 per board.
- Ivory White
- Bone White
- Desert Tan
- Latte Brown
- Terracotta
- Dark Red
- Dark Brown
- Ash Gray
- Nardo Gray
- Charcoal
- Dark Blue
- Ice Blue
- Dark Green
- Lemon Yellow